HeinzBikes LED indicator/rear light Block Line Micro M8 black

Description

HeinzBikes LED Aluminum Indicator/Tail light pair Block Line Micro M8

Small universal direction indicators with integrated tail/brake lights with tinted glass.

Details:

• robust and light CNC milled aluminum case
• attachment through M8x1.25 thread and nut
• each 5 very bright LED
• 12 volt, tail light/brake light/turn signal: ../../.. watt

Measurements (each):
width without thread x height x depth: 40 x 11 x 18 mm
diameter on the base: 12 mm
thread length: 15 mm
cable length: 30 cm (open cable ends)
weight: each 20 g

Cable configuration:
blue  = turn signal +
yellow  = tail light +
red = brake light +
black = mass -

ATTENTION:
When using LED turn signals on vehicles that do not have them in their original state, it may be necessary to exchange the flasher relay or/and to reduce the flash frequency to an acceptable value through resistors.

Options:

• in the event that the legal distances cannot be maintained or if the number plate is in the way, appropriately long extensions can be utilized for the indicator arm (order number 50170400860, 50170400870 or 50170400871)
• for a simpler attachment without changes to the cables of the original turn signals, there are a number of adapter cables for a range of manufacturers/models (order number 50170003460 and following  as well as 50170502000 and following)
• its mount is oftentimes too big in the event that the installation shall replace the original turn signals - there are a number of adapter plates for a range of manufacturers/models which make the installation possible (order number 50170100000 and following)
• including the adjustable resistance even for models with a CAN bus system (order number 50220000640)
• available in the version with integrated position light in the front (order number 50170702020 and 50170702021) or available as a pure indicator (order number 50170702000 and 50170702001)

Certification:
With EC certificate for the back.
The turn signals and the position lights dispose of an EC certificate and do not require any other certificates.
Therefore, they can simply be installed by following the assembly instructions.

For motorcycles with EC certificate (from approx. mid/end '90s), the following applies:
Minimum distance between turn signal glass to turn signal glass back: 180 mm
Maximum distance back turn signal to the extreme end of the rear: 300 mm
approved installation height: 350 to 1200 mm
geometric visibility to the inside/outside: 20/80 degrees
geometric visibility up/down: 15 degrees
approved flashing frequency: 60 to 120 cycles per minute
For older models, vehicles that entered traffic through single approval or that are only valid in a non-EU country there could be diverging measurements.

Price per unit