Kellermann handlebar tail BL 1000 Halogen 12V/H21W alu semiflat sharpe

Description

Kellermann Handlebar Indicator BL 1000 Halogen 12V/H21W

Universal direction indicator for front and handlebar weight in one.

Details:

• turn signal control through the glass on the back also possible on the turn signal itself
• this ensures better visibility too
• high-quality handlebar weight milled from a solid block
• safely and securely fastened to the handlebar end by the various rubber clamps included in the delivery
• suitable for almost all handlebars with an inner diameter of 11-22 mm - almost all have this size; only a few original handlebars have a smaller Ø
• alu version is slightly lighter than the versions made of stainless steel & nbsp;or made of brass
• no matter what material the handlebar end is, it always acts very effective for damping the handlebar vibrations while driving
• It is with 12 volts, 21 watt halogen bulb
• For vehicles that have 21 watt turn signals in the original, there is NO need to change the electrical system (resistors, other flasher relay, etc.)
• Made in Germany

Measurements(ca.):
width from the bar ti the end is: 65 mm
Diameter at the handlebar end / maximum is: 30/36 mm
Cable length from handlebar end is: 65 cm
Weight: depending on the version, between 130-150 g

Cable assignment:
Blinker + = gray
Mass - = takes place via the housing to the handlebar - if necessary, a separate cable must be laid on its own if the handlebar doesn't
open cable end to allow easy installation by the handlebar

Options:

• for an easier connection, without change the cables of the original turn signals, there are many models of adapter cables by different manufacturers (order number 50170003460 and following  such as 50170502000 and next)
• drilling template for secure attachment of the holes in the handlebar for the cables (order number 50180808000)
• also available in a version with LED technology with either clear or highly tinted glass (order numbers 60490000275, 60490000276 and 60490000277)
• replacement bulb 12 Volt Halogen 21 Watt BAY9S (order number 50150000391)

Certification:
With CE certification mark as a turn signak for the front.
The turn signals have a CE certification mark and require no further paperwork.
Therefore, you can easily install them according to the mounting instructions without further ado.

For motorcycles with CE certification (from approx. mid/end of the 1990s):
allowed mounting height is 350 to 1200 mm
geometric visibility inwards/outwards is 20/80 degrees - pay attention to the back of the handlebar!
geometrical visibility up and down: 15 degrees - pay attention to the offset of the handlebar up or down!
allowed flashing frequency is 60 to 120 cycles per minute
For older models, for vehicles which have been put on the market individually or in non-EU member states, different dimensions can be applied.