Shin Yo LED indicator pair Peak M10 short carbonlook, tinted glass

Description

Shin Yo LED turn signal pair Peak M8

Universal turn signal with blinker at the tip.

Details:

• light plastic case
• with long-lasting rubber base to protect against vibrations
• installation with M10x1.25 thread and nut
• bright LED
• monitoring the signal is also possible at the turn signal itself, due to lens at the tip of the back side
• 12 Volt, 6 Watt

Measurements (approx.):
width x height x depth without stem: 46 x 27 x 27 mm
total length without thread short/long: 66/86 mm
length of thread: 20 mm
length of cable: 12 cm
push-on connectors: 3.5 mm
weight short/long: 33/38 g each

Cable configuration:
yellow = plus turn signal
black = ground

ATTENTION:
When using LED turn signals on vehicles that don't have them in the original, it may be necessary to replace the indicator relay and/or reduce the flashing frequency to a level allowed by using resistors.

Options:

• also available with 21 Watt bulb (order nr. 50170400320 and following)
• if otherwise the legally required distances cannot be met or if the number plate is in the way, extra matching extensions can be used for the turn signal arm (order nr. 50170400860, 50170400870 or 50170400871)
• for easier connection without changes to the cables of the original turn signals, there are suitable adapter cables available for many manufacturers/models (order nr. 50170003460 and following  as well as 50170502000 and following)
• if mounting is to be done instead of using the original turn signals, it will most likely be too big - for many manufacturers/models, there are suitable adapter plates with which mounting is then easier (order nr. 50170100000 and following)

Certification:
With CE certification mark for front and rear.
The turn signals have a CE certification mark and require no further paperwork.
Therefore, you can easily install them according to the mounting instructions without further ado.

For motorcycles with CE certification marks (from approx. mid/end of the 1990s):
Minimum distance turn signal to turn signal front/rear is: 240/180 mm
Minimum distance turn signal to headlamp glass is: 75 mm
Maximum rear turn indicator distance to the far end of the tail: 300 mm
Allowed mounting height is between: 350 to 1200 mm
Geometric visibility to the inside/outside: 20/80 degrees
gGeometric visibility to the top and bottom: 15 degrees
Allowed flashing frequency is: 60 to 120 cycles per minute
For older models, for vehicles which have been put on the market individually or in non-EU member states, different dimensions can be applied

Price per pair